Range Rover Console
Ex VAT £65.00
Range Rover Console, designed to fit the hard dash Range Rover. Simple fitting by removing the dash top tray and bolting through the 2 existing holes.
Please note that switches are fine for clearance on the bottom of the panel but it is somtimes necessary to cut away part of the plastic covering of the dash if you ar having guages or anything deeper than a switch. Towards the top of the panel there are no restrictions and the Console will take the depth of a standard radio with room to spare.
If it is your intention to fit a CB radio under the main radio you will need to stick to the sizes that match the cut outs in the panel as the CB should not be wider that the tray in the top of your dash in order to get the clearance at the sides.
If you are having your CB in the bottom section of the front panel (below the centre screws the maximum sizes for your CB without cutting away any of the dashboard is 180mm wide and 130mm deep (front to back) there are no real restrictions on height. If your CB is going in the top section (above the 2 centre screws) any CB will fit.In the top section you have a full 190mm of depth.
Dimentions of the Console are as follows. 330 wide tapering up to 270 at the top. 160mm high at the front and 200mm deep.
Special Cuts There is an extra charge of £12.00 for a special cut panel due to programming - please ensure you chose Provide Speficifications(+12.00) in the panel dropdown choice - there is a section in the checkout area to leave a note of your requirements
Write a review
Your Name:Your Review: Note: HTML is not translated!
Rating: Bad Good
Enter the code in the box below:
| R1 |
 |
Plain panel to cut to your own requirement |
| R2 |
 |
Radio Din, 10 Carling switches. |
| R3 |
 |
Radio din only |
| R4 |
 |
Radio din. CB radio 124 x 38.and 4 12 Volt toggle switches |
| R5 |
 |
Radio Din, 2 carling switches4- 52mm guages |